Z-Wave controlled DIN mounting RGBW/PWM LED controller. Controller uses PWM output signal, which enables it to control LED, RGB, RGBW strips, halogen lights and fans. Controlled devices may be powered by 12 or 24VDC. In addition the device supports up to four analog or binary input. 0-10V analog sensors, such as temperature sensors, humidity sensors, wind sensors, air quality sensors, light sensors etc. All IN and OUT terminals may be user configured for LED control or 0-10V signal readouts. The module supports power reading and remote firmware update. 

Features:

• Ventilated DIN enclosure
• 16A rated PCB power tracks and terminals
• Fibaro FGRGBW-442 included
• Controlled by momentary or toggle switches
• Power Supply: 12 V DC / 24 V DC;
• Rated output power: combined 12A (sum of all connected output channels), 6A for single output channel;
• PWM output frequency: 244 Hz;
• Electricity consumption: 0,3W;
• Radio signal power: 1mW;
• Max load (e.g. halogen bulbs): at 12V - 144W combined, at 24V - 288W combined;
  
• To be mounted on standard DIN Rail
• Radio protocol: Z-Wave Plus, 868 MHz
• Antenna range: up to 50 meters outdoor / 30 meters inside (depends on building structure)

RGBW Controller 2 may control:

• 12 / 24VDC powered RGB strips;
• 12 / 24VDC powered RGBW strips;
• 12 / 24VDC powered LED strips, bulbs, etc. ;
• 12 / 24VDC powered halogen lights;
• 12 / 24VDC powered low output power fans; 

Analog Inputs:

• 0-10V sensors signal readouts;
• 0-10V potentiometer signal readouts, and managing outputs accordingly;

Using sensors with 0-10V outputs along with the controller, it’s possible to implement solutions based on the following readings: Humidity, External/internal temperature, Wind speed, Precipitation, Luminosity level, Soil humidity, Air quality, Inside humidity, Air pressure, CO2 and CO levels, Calcium levels, Ph levels, Distance / Proximity;